Technical Parameters of the New Type of low speed Edge Plastics Crusher | ||||
Power | Crushing CapacityKG/H | Inlet dimension(MM) | Rotary chamber(MM) | Rotary speed(R/MIN) |
1HP/0.75KW | 15-25 | 140×215 | Ф140 | 145 |
2HP/1.5KW | 30-50 | 174×260 | Ф175 | 145 |
3HP2.2KW | 40-80 | 230×260 | Ф175 | 145 |
5HP/4KW | 60-120 | 315×312 | Ф205 | 145 |
New type of low-speed edge plastic crusher product description:
specially designed for crushing scrap and gate of injection molding machine crusher,except having the general low speed crusher common advantages, such as low noise, almost no dust particles from the outside.The new edge low-speed granulator also has better performance, such as special design of the cutting tool, rotor, the quickest way to boot, and ease of accessibility. Applicable to broken pieces of PVC, PC, ABS, PU, soft hard shuikou material such as PA6; Widely used in the following enterprise, electronic, plastic container factory, lighting factory, shoe factory, electrical equipment, automobile accessories factory, bags factory smoke grain factory, waste recycling plant, plastic furniture factory, toy factory, plastic kitchenware factory, etc.
Dedicated tool makes no adjustment after resharpening.
The rotor is equipped with specially designed tools, special rotor knives to ensure they remain fixed angle after resharpening cutting curves and cutting interval, because of the complicated adjustment need not again after the tooling process, thus it significantly shortens the disassembling tool downtime.
Solid rotor device
Rotor bears on two bearings, at the same time, the diameter of axle is designed according to the maximum width of rotor to make it impossible to chop the blocks. In addition, stepped rotor blade design makes any moment only a tool for cutting, so as to gain the cutting torque.
The fast way of teardown
A new efficient teardown mode makes the machine easy to be removed, so it is easy to clean the broken , lower part of the machine plate by two strong fixture, when remove the front panel, safety switch installed in the machines can prevent idling, external rotor bearing installed in front of the fixed plate above.
Ease of accessibility
Remove the machine safely without using any tool, machine.The feeding hopper is linked with the fuselage through chain. You can open from the back, open the lower part of the machine plate and take out after hopper.The machine can be carried out on the cleaning, so it solves the problems of the machine needs to clean up.when its color or material qualitative changes.